Microsine - Permanent Magnetic Sinetables

These highly accurate Magnet Sinetables are used for grinding work as well as for eroding. It allows for universal clamping of small, medium and large workpieces of any thickness, however, they are best suitable for thin and fine workpieces. The permanent Microsine magnetic clamping plate is preferably used if a flat and light construction is needed during grinding, eroding or milling. A complete, fine transverse pole distribution (steel/brass) guarantees a consistent holding force over the entire width up to the longitudinal sides. This clamping plate can be activated through a hexagonal switch lever. They are available in two versions: either single-pivotable via the longitudinal axis or double-pivotable via the longitudinal and transverse axis. Gauge blocks can be used to set the tilt angle precisely up to 45 °. The magnet Sinetable is suitable for accurate grinding of workpieces with nonparallel surfaces. Individual designs can be created on request. MS SI 1710:Item No. 42468 MS SI 3015:Item No. 27748 MS SI 4515:Item No. 63100 MS SI 6030:on request