Продукти за g7sa 4a2b dc24 (4)

The output shaft of the HSH swivel motors has radial and axial hydrostatic bearings. Here, radially and axially arranged bearing pockets are supplied with pressurized oil via a separate pressure connection. As a result, the output shaft is centered radially and axially between liquid cushions and all metallic contact surfaces are permanently separated from each other by a thin liquid film. This eliminates wear caused by metallic friction in any operating state, even at zero speed compared to hydrodynamic plain bearings. In conjunction with highly dynamic control valves and angle of rotation sensors, these actuators are preferably used in controlled systems in which disturbance variables such as friction and the stick-slip effect must be reduced to a minimum. Furthermore, due to the lack of internal seals, they are ideal for test series with large numbers of load cycles where an interruption, e.g. due to the replacement of internal seals, is not permitted. Specific torque [Nm/bar]:32,80 Operating pressure [bar]:280 Nominal torque [Nm]:9184 Swivelling angle [ degrees° ]:120

24VDC / 5VDC 10A

90 V AC bis 265 V AC, Weitbereichsnetzteil, 4 A, geeignet für alle AS-i Gateways und Sicherheitsmonitore von Bihl+Wiedemann.

Caratteristica — Motori CC a magnete permanente — Spazzole in grafite e rame — Carcassa del motore zincata — Cuscinetti a sfera — Fori di montaggio secondo le norme DIN 42016 Dati generali — Durata appros.: 3000 h — Carico max sullalbero: assiale 40 N — Carico max sullalbero: radiale 100 N — Classe d'isolamento: DIN VDE 0530, E — Classe di protezione: DIN VDE 0530, IP 40 — Soppressione RFI: fattibile AC/DC:DC Tipo:sincrono Tensione:10 V...50 V,5V Altre caratteristiche:a magneti permanenti