Продукти за cleanmymac x (2)

Consilex Muffa Cleaner Transparent, ready-to-use cleaning agent, for the safe removal of scale blackish incrustations from moulds and biodeteriogenic manifestations, as well as for the revitalising renewal of wooden surfaces. It is particularly recommended for the cleaning and removal of the brown and blackish incrustations caused by humidity and mould, on masonry, internal and external plasters, chalk coatings, lime, cement, paint, plastic, wooden surfaces. It can be used effectively also for the restoration and renewal of wooden surfaces degraded and blackened by humidity and the weather. Cleaning and removal of deposits and stains caused by moulds and biodeteriogenic manifestations. Renovation and maintenance of wooden surfaces degraded by moulds and moisture. AS A CLEANING, DAMP PROOFING AGENT: Apply the product by spraying or brushing the surfaces to be cleaned, leave to work for a period of time ranging from 30 minutes to one hour; then remove the product with a sponge and rinse with water. In the case of particularly resistant concretions, repeat the operations described until their complete elimination. AS WOOD RENEWER: For surface cleaning, for example, before repainting, apply the product until rejection on soiled and/or blackened parts, with a sprayer or a brush. Remove the product after a few minutes with a damp sponge or brush with water. For a deeper treatment, to renew the original natural appearance of wood, leave the product to work for at least 12 hours. Then proceed with the removal of fouling with a brush and water and, after drying, proceed with the protective repainting with appropriate flatting or with transparent paints. Approximately 0,20 litres of Consilex Muffa Cleaner for every square metre of surface to be treated. Packaging: 1-liter can UM: €/l

Syntech HAG Cleaner Cleaning agent specific for the necessary equipment during operations of injections to stop the infiltration of water in the buildings. Oily rinsing detergent, low toxicity, high solvent capacity for non-hardened polyurethanes, to clean and lubricate the internal pumping hydraulic circuits of both manual and electric pumps. It replaces acetone, methylene chloride and other detergents commonly used. Cleaning the equipment for water-reactive polyurethane injections in the masonry. Removal of the non-hardened polyurethane residues. Upon completion of the operations of injection of water-reactive polyurethane-based masonry products, it is necessary to perform a careful cleaning of pumping equipment before their resting. To this end, first circulate Nitro thinner in the hydraulic circuits of the pump for a few minutes, in order to rapidly dissolve the hardened polyurethane residues. After cleaning the pumping circuits, circulate the specific detergent oil lubricant SYNTECH H.A.G. CLEANER, undiluted, for a few minutes, in the same circuits. A small amount of product must be left inside the pumping circuits in order to keep them lubricated during the resting period of the pump. The estimated consumption will be approximately 2 litres for every clean pump per working day. Product to buy as needed. Can 10 kg